Textron Bell 412 - LANDING GEAR SYSTEM

BHT-412-MM-2
5-00-00
Page 12 Rev. 16 26 FEB 2013
Export Classification C, ECCN EAR99
Chapter 30 WINDSHIELD WIPER
Visually inspect windshield wiper blades for serviceability and
security.
Chapter 32 LANDING GEAR SYSTEM
1. Visually inspect landing gear as follows:
a. Forward crosstube and cap fittings for condition and
security of attachment.
b. Aft crosstube, cap fittings, and wear strips for condition
and security of attachment.
c. Aft crosstube support beam for wear, cracks, damage,
corrosion, and security of attachment.
d. Skid tubes and skid shoes for condition and security of
attachment. Replace skid shoes that are worn into shoe
surface. Repair weld beads as required.
e. Fuselage supports for wear, damage, and security of
attachment.
f. Deleted.
g. If installed, landing gear forward crosstube crew step
fittings for corrosion, damage, and security in area of
attachment. If edge sealant is damaged or missing, remove
crew step and inspect crosstube for corrosion or damage.
h. Emergency float reservoir pressure indicator for proper
charge indication (if installed).
i. Floats for proper stowage and condition (if installed).
2. Visually inspect tail skid for deformation and security of
attachment.
Chapter 52 DOORS, WINDOWS, AND EMERGENCY EXIT
1. Visually inspect nose door for obvious damage, security of
attachment, proper latching, and seal for condition.
SCHEDULED INSPECTIONS
5-5. DAILY INSPECTION — PART A (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER