11
ZT 200
Series
MAINTENANCE
ENGINE OIL
Do not perform engine maintenance without the engine
off and PTO disengaged.
AFTER FIRST FIVE (5) HOURS
While the engine is warm:
1. Remove drain plug D and drain the crankcase.
Dispose of used oil in accordance with local
requirements.
2. Clean and replace the plug D.
3. Change oil filter F. See Engine Manual
4. Remove cap C and fill the crankcase with fresh oil
to the full mark on the dipstick. Do not overfill. See
engine manual for oil specifications.
DAILY
1. Check oil level with the dipstick.
2. If oil is needed, add fresh oil of proper viscosity
and grade. See engine manual for oil specifica-
tions. Do not overfill.
3. Replace dipstick before starting engine.
PERIODIC OIL CHANGES
1. See engine manual for oil and filter change
intervals after the break-in period.
2. Follow instructions for first oil change, above.
FUEL FILTER
An in-line fuel filter S is located at the right side of the
engine. Inspect at every oil change to make sure fuel
filter is clean an unobstructed. Replace if dirty or after
400 hours of use.
To Next Page
Loading...
Need help?
General
