2180
Estate
Series
8
LUBRICATION
Every 50 hours of operation, lubricate the following points (1-6) with grease:
1. Deck lift rockshaft (1 point)
2. Deck idler pivot bearings (2 points)
3. Deck lift pivots (6 points)
4. Hydro belt tensioner (1 point under engine deck)
5. Brake lever pivot (1 point)
6. Push arms (2 points located at rear of cutter deck under each fuel tank)
7. Caster wheel pivots (2 points)
(Lubricate every 500 hours or once a year)
NOTE ON BLADE SPINDLES - The blade spindles on these machines use
a superior sealed bearing that does not require relubrication.
MAINTENANCE
To Next Page
Loading...
