2180
Estate
Series
15
Parking brake assembly (Tire and deck not shown
for clarity - brake in ON position).
PARKING BRAKE
Start with parking brake N in the OFF position.
1. Disconnect one end of rods M (at brakes on both
sides of the machine).
2. Move the parking brake lever to the ON position.
3. Adjust rods M on each brake to be 3/4” short of
connecting to the spring when all the slack is
taken out of the brake linkage and brake lever N.
4. Move the parking brake to the OFF position and
reconnect rods M.
This adjustment will cause the brake springs to
stretch 3/4” when the brake is in the ON position to
provide the correct parking brake force without
overloading the brake.
ADJUSTMENTS
To Next Page
Loading...
