CONTROLS 4
GB-11
R. Traction Control
Press and release switch to activate traction control
system. This system
reduces down pressure on decks
by pulsing the lift circuit, transferring weight to tractor.
Reducing down pressure improves traction but may
cause decks to float up creating an uneven cut. Light
in switch will turn on when system is active.
Press switch again to deactivate traction control. This
may reduce traction but improves deck contact with
ground.
NOTE: The traction control system must be reset after
shutting off engine.
S. Lights
Controls operation of work lights.
T. Engine Throttle
Controls engine speed. Run machine at full throttle
during normal machine operation.
U. Cruise Control (Option)
When switched ON the cruise control will lock the
traction pedal in its current position. Cruise will unlock
when switched OFF, or if parking brake is applied.
V. Ignition Switch
The ignition switch has three positions. OFF- RUN (ON)
- START. In the RUN (ON) position the controller
program is running and input and output circuits are
being monitored. See Section 5.4 and Parts &
Maintenance Manual.
W. Hour Meter
Records engine operating hours. Use hour meter to
schedule periodic maintenance.
X. Fuel Gauge
Indicates current fuel level. Check fuel gauge daily
before starting machine.
Y. Warning Lights
Alerts the operator to conditions requiring immediate
action. See Section 4.4.
Z. Temperature Gauge
Indicates engine coolant temperature. Normal operating
temperature should be between 160° - 230°F (71°-
110°C). If temperature rises above 230° (110°F), alarm
will sound. See Section 4.4.
To Next Page
Loading...
Need help?
General
