4
Hydro
Midsize
8. After installing handles, make sure to check the
throttle and choke setting are correct.
Check the throttle at idle and full throttle. The
lever should contact the upper stop at idle and
thelower stop at full throttle.
Make sure the choke is fully open with the choke
cable pused all of the way in, and fully choked
with the cable pulled all of the ay out.
LOW IDLE STOP
HIGH IDLE STOP
HIGH IDLE STOP
WITH THE CHOKE CABLE PUSHED IN,
THE TWO LEVERS SHOULD ALMOST
TOUCH.
ASSEMBLY/SET-UP INSTRUCTIONS
4. Install upper handle B to lower handle D using
(2) 3/8-16 X 1-1/2" bolts and (2) 3/8-16 serrated
ange nuts through upper holes F. Install (2) 3/8-
16 X 1 bolts and (2) 3/8-16 locknuts through hole
E and one of the three holes on D to give desired
handle height.
5. Loosen bolt X connecting the brace Y to lower
handles. Align top of brace so the upper handle
B is between the slot and hole.
6. Install U bolt U around upper handle and through
hole and lot in the brace.
7. Install nylock nuts W on both ends of U-bolt and
tighten. Repeat on other side.
To Next Page
Loading...
