TFA ICON - Alarm Functionality

2726
ICON – Design Radio-controlled alarm clock

ICON – Design Radio-controlled alarm clock

• A1 and 6:00 (default) or the last adjusted alarm time appear on the display.
• Press and hold the MODE button for 2 seconds.
• The hour digits flash.
• Press the UP or DOWN button to adjust the hours.
• Confirm with the MODE button.
• Set the minutes in the same way.
• Confirm with the MODE button.
• 5 (default) or the last adjusted snooze interval appears on the display.
• Press the UP or DOWN button to set the desired time duration (5 to 60 minutes).
• Confirm with the MODE button.
• To activate the alarm function slide the ALARM ON/OFF switch to ON.
• The alarm symbol appears on the display.
• When the adjusted alarm time is reached, the alarm rings.
• Press any button (except SNOOZE/LIGHT) and the alarm will stop.
• The alarm symbol remains on the display.
• If the alarm is not stopped manually, the ascending alarm tone automatically turns off after two minutes
and it will be reactivated at the same set time on the following day.
• When the alarm rings, press the SNOOZE/LIGHT sensor button briefly and the snooze function is activated.
• Once the snooze function is activated, the snooze symbol will be flashing on the display.
7.2 Time setting
• Press and hold the MODE button in normal mode for 2 seconds.
• 00 (default) will be flashing. Press the UP or DOWN to adjust the time zone (00, 01, -01).
• The time zone correction is needed for countries where the DCF signal can be received but the time zone
is different from the DCF time (e.g. +1=one hour plus).
• Confirm with the MODE button.
• The hour digits flash.
• Press the UP or DOWN button to adjust the hours.
• Confirm with the MODE button.
• Set the minutes in the same way.
• Confirm with the MODE button.
• The manually set time is overwritten once the DCF time signal is successfully received.
7.2.1 24- or 12-hour system setting
• Press the DOWN button in normal mode to choose between the 12 - or 24-hour system.
• In 12 HR system PM appears after 12 h on the display.
7.3 Alarm time setting
• Press the MODE button in normal mode to enter the alarm mode.
TFA_No. 60.2543_Anleit_02_20 27.02.2020 17:28 Uhr Seite 14