10.MAINTEINANCE
T h e m a i n t e n a n c e p r o c e d u r e s d e s c r i b e d b e l o w , c a n o n l y b e p e r f o r m e d b y a u t h o r i z e d p e r s o n n e l .
a s d e f i n e d In t h e
sa\e!gratuitous loan for use
c o n t r a c t . P l e a s e r e f e r t o s u c h d o c u m e n t a n d / o r t h e
D e a l e r if in a n y d o u b t .
Maintenance procedures are:
• LIGHT-BULB REPLACEMENT
• FUSES REPLACEMENT
LIGHT-BULB RE PLACEMFNT
W A R N I N G : b e f o r e p e r f o r m i n g a n y o f t h e s t e p s l i s t e d b e l o w , m a k e s u r e t h a t t h e m a i n s w i t c h b e
in t h e " 0 " p o s i t i o n a n d t h e p o w e r c a b l e b e d i s c o n n e c t e d .
A
| \ WARNING: burn hazard: Make sure that the unit be switched o ff for at least 30 minutes
before opening the external shell.
Replacing of the light bulb must be carried out by an expert. It is advisable to replace the lamp
before 2,000 hours of operation, or less if broken or exausted.
The replacement bulb must be new and identical to the one replaced (mod. Osram SIG64004)
(Pic.12-13). 77
Replacing of the light bulb must be carried out by an expert. It is advisable to replace the lamp
before 2,000 hours of operation, or less if broken or exausted.
The replacement bulb must be new and identical to the one replaced (mod. Osram SIG64004)
(Fig12-13).
1 .Rotate the unit upside/down.
2.Open the cover by pressing with a screwdriver on the plastic lid (Fig.12A,B). unscrew the
three screws visible on the metallic surface underneath (Fig.l2C).
S.Pull out the bulb case (Fig.l3A).
4.Disconnect the two faston connectors and replace the bulb (Fig.13B-C).
5.Reposition the new bulb in its housing, reconnect the faston, reinsert the bulb case and
fasten the three screws.
6.close the cover and rotate back the unit.
7.Connect the unit to the mains.
8.Reset Lamp Counter: press INFO/SCORRI(=>-^) till the message:
R e s e t L a m p C o u n t e r
is
displayed.
9.Press START (►), confirm by pressing START (►), again. Display:
L a m p C o u n t e r
= 0!
10.Verify the correct functioning of the bulb.
If the problem persists, contact your authorised dealer.
FUSES RAPLACEMENI
Open the fuse-box, placed on top of the main switch on the back-panel (Pic. 14) by pressing
with a screwdriver. Pull out the fuses and replace them with new ones with identical
carachteristics.
If the problem persists, contact your authorised dealer.
u
Информация получена с официального сайта
Федеральной службы по надзору в сфере здравоохранения
www.roszdravnadzor.ru
To Next Page
Loading...