Need help?Do you have a question about the The t.racks DS 2/4 and is the answer not in the manual?
General| Brand | The t.racks |
|---|---|
| Model | DS 2/4 |
| Category | Recording Equipment |
| Language | English |
Provides an overview of the symbols and signal words used in this user manual.
Defines the proper and intended application of the device for safe operation.
Covers crucial safety advice, including electrical hazards, fire risks, and proper usage conditions.
Details the procedure for mounting the unit in a standard 19-inch rack.
Explains the XLR pin assignment for balanced signal connections.
Identifies and describes the controls and indicators on the front panel of the device.
Details the connectors and ports located on the rear panel of the device.
Accesses settings for crossover frequencies within the device menu.
Allows loading of previously stored audio configurations or presets.
Guides on creating and configuring custom crossover settings for audio outputs.
Explains how to save user-defined configurations and settings to memory slots.
Describes the process for deleting stored configurations from the device's memory.
Manages access rights and password protection for device parameters.
Details the procedure for entering a password to access protected device settings.
Allows adjustment of various device settings and operational parameters.
Function to link two outputs for synchronized stereo operation.
Configures how the device activates, offering options like fade-in or mute hold.
Sets runtime delay for speaker management, using units like meters, feet, or milliseconds.
Configures RS232 interface speed and device ID for communication.
Assigns designations or names to the device's outputs from a predefined list.
Verifies input source assignments (A and B) but does not allow changes.
Provides access to adjust various device parameters, potentially requiring a password.
Instructions for cleaning the device's fan grids to remove dust and dirt.
Guidelines for environmentally friendly disposal and recycling of packaging materials.
Procedures for proper disposal of the electronic device according to WEEE regulations.
To Next Page