destination. It could also create shares automatically from
destination if it is not existent. This only applies if the target
server is the same model as the source.
Full Backup
Click on full backup and the setup screen appear as below. Fill in the remote target
IP (Destination) and port (need to be changed only if this port is already in use).
If encryption is required then enable it. Please make sure the associated target
server also has encryption enabled.
Carry on with inputting valid remote target server account name and password.
After the settings are complete, please click on “Connection Test”. The source unit
will try to connect with the associated target system. If a connection can be built up
successfully then “Connection passed” will be prompted, otherwise “Failed” will
appear.
Click “Next” and more setting will appear.
To Next Page
Loading...
