2. Install HDD on the tray, as the following chart:
3. Install the tray with HDD into N0204 miniNAS,
please note that the HDD-1 is in left side and
HDD-2 is in right side. The triangular symbol of
tray must be corresponding with the triangular
symbol of back panel. Push the tray back.
Cable Connections
To connect the N0204 miniNAS to your network, follow the steps below:
1. Connect an Ethernet cable from your
network to the LAN port on the back
panel of the N0204 miniNAS.
2. Connect the provided power adaptor into
the power socket on the back panel.
Plug the other end of the cord into a surge
protector socket.
To Next Page
Loading...
