3. Press the Power button on the Rear end to boot up or shut down the N0204
miniNAS.
Chapter 3: First Time Setup
Overview
Once the hardware is installed, physically connected to your network, and powered
on, you can configure the N0204 miniNAS so that it is accessible to your network
users. There is one way to set up your N0204 miniNAS: using the Thecus Smart
Utility. Follow the steps below for initial software setup.
Thecus Smart Utility
The handy Thecus Smart Utility makes configuring N0204 miniNAS a snap. To
configure the N0204 miniNAS using the Smart Utility, perform the following steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2. The Smart Utility should launch automatically. If not, please browse your
CD-ROM drive and double click on autorun.exe. Click “N0204”.
NOTE
For MAC OS X users, double click on Thecus Smart Utility Wizard .pkg file.
NOTE
1. USB copy LED will be
flashed Blue light during
the system are booting
and will be dull after the
booting complete.
2. To shut down the
system, press the power
button over 4 seconds,
then USB copy LED will
To Next Page
Loading...
Need help?
General
