2 options can be chosen:
Fast: suitable for single disk to many tasks but less information to
be displayed
Full: suitable for single to single disk operation and will have a
complete log recorded during operation
High-Availability (N8900, N12000 series/N16000 series only)
HA keeps your data active on two separate systems, Thecus Supports
Active/Passive HA — provides a fully redundant instance of each node, which is only
brought online when its associated primary node fails.
HA setup procedure:
HA needs two identical Thecus systems (same models and same hard disk slot
installed) which are capable for high availability features. One needs to be setup as
“Primary” and the second unit as “Secondary”, both units’ needs to have the RAID
volume build up prior installation.
Let’s see an example with two Thecus Units.
Please be notified that if the system has been
used as a standalone station before and
contained more than one RAID volume with
data inside, once it is used for HA, all of data
will be destroyed.
To Next Page
Loading...
Need help?
General
