After clicking “Next”, a screen will appear as shown below. Listed on the left hand side, you 4.
will see the configuration backup details which contain the 3 RAID volumes. On the right
hand side, you will see a list of single “RAID ” volume. You may roll back to previous page to
recall the example we have taken.
The backup configuration has different numbers of RAID volume than the current system (3 5.
vs 1). It can be kept as the RAID volume mapping arranged by the system, then carry on to
click “Finish”. This means that all 3 RAID volumes configuration such as share folder etc. will all
restore to the current unit in the RAID volume “RAID”.
In other circumstances, if the current unit contains 2 RAID volumes, then it can be chosen 6.
from the left hand side of system backup configuration RAID volume list which RAID volume
to map to the current system.
Let’s see the following screen to make it clearer.
The current system has 2 RAID volumes, “RAID” and “RAIDa”. Select the RAID volume from the backup
configuration volume list which is going to be mapped to the RAID volume of the current system.
Simply click on the right hand side of “RAIDa” and a drop down list will appear. Now you can choose
which volume to map with. In this case the “RAID01” volume from the system backup configuration
To Next Page
Loading...
