MAINTAINING YOUR ALLCLEAR
™
G2 FILTER:
Step 2
Unscrew Compression Nut
Unscrew the compression nut and gently pull out the
quartz sleeve.
Step 3
Remove UV Bulb
Pull gently on the base of the UV bulb to remove it.
Step 4
Insert New Bulb
Insert the new bulb taking care not to touch the bulb
as the oils from your hands can cause damage.
Step 6
Clean Quartz Sleeve
Clean the quartz sleeve with a soft cloth or sponge.
The quartz sleeve should be cleaned yearly or when
water clarity is reduced. You may nd the use of Pond
Equipment Cleaner helpful for removing debris. If the
quartz sleeve if it is scratched, damaged, or cracked, it
must be replaced.
Step 5
Transfer Protective Cap
Transfer the rubber protective cap from your old bulb
onto the new one.
thepondguy.com | 866-POND-HELP (766-3435)
10
To Next Page
