ThePondguy AllClear G2 2000 - Maintaining Your AllClear G2 Filter: UV and Sleeve; UV Bulb and Quartz Sleeve Replacement

Step 3
Replace Media Pads
Replace the media, keeping the pads in the same
order as the ones you removed.
Step 4
Place the Base Back
Place the base back onto the lter media and secure to
the rods with the 2 screws.
Step 5
Replace Filter Top
Replace the lter top, be sure the lter o-ring is
properly seated, and secure with the lter clamp.
Step 1
Remove Filter Top Screws
Use a phillips screwdriver to remove the 4 screws
securing the UV to the lter top.
REPLACING UV BULB AND CLEANING/
REPLACING THE QUARTZ SLEEVE
Over time the eectiveness of the UV bulb will degrade. We recommend replacing the UV bulb
once a year, even if the bulb operates, to maintain maximum results. The quartz sleeve should
be cleaned yearly or when water clarity is reduced. Note: Condensation may form on the
quartz sleeve. This cannot be avoided and does not impair the function or safety of the unit.
MAINTAINING YOUR ALLCLEAR
™
G2 FILTER:
15425 Chets Way | Armada, MI 48005
9