Handlebar Adjustment
One of the Theracycle’s many unique features is its handlebars, which move
forward and back to give your upper body a workout.
1. With the 5/16” allen wrench, loosen the allen nut on the top of the
handlebar assembly by turning it counterclockwise.
2. Rotate the handlebar to desired position and tighten the bolt clockwise. Be
certain this bolt has been firmly tightened.
3. When the handlebars approach the user, they should be angled toward the
hip and above the knee.
Pedal Strap and Pedal Crank Adjustment
On the Theracycle you can adjust the size of the pedal arc by adjusting the angle
of the pedal link. You can also adjust the size of the pedal strap.
1. With the 5/16” allen wrench, loosen the allen bolt, which attaches the
pedal link to the pedal crank, counterclockwise. When it is loose, you
can rotate the pedal link to your desired angle. This angle changes the
size of the arc, or range of motion that your foot and therefore your leg will
travel.
2. Once you have determined the proper angle, secure by tightening the
allen bolt clockwise.
3. Once one pedal is adjusted, make sure to adjust the other pedal in
exactly the same way so that each pedal mirrors the other.
4. To adjust each pedal strap, push down with one hand on top of the clip
holding the pedal strap. With your other hand, push the strap to the
desired position, and release.
There are instructional videos on these adjustments. Go to
https://www.youtube.com/user/Theracycle.
To Next Page