Now that you have assembled the Theracycle, you will need to adjust it for a
customized fit. In the section labeled, “Adjusting Your Theracycle,” you will find
the directions to do this.
Please contact our customer service department with questions about assembly
or about the use of your Theracycle, Monday-Friday, 9:00AM – 5:00PM. EST.
Call 508-528-3100.
Adjusting Your Theracycle
To get the greatest benefit and comfort from your new Theracycle, there are
a few custom adjustments that you should make.
Tools needed: 5/16” and 3/16” allen wrenches (provided)
• Seat adjustments
• Handlebar adjustments
• Pedal adjustments
Seat Adjustment
By properly aligning your Theracycle seat, you will ensure maximum comfort as
well as safety and efficiency.
There are three different seat adjustments for the Theracycle. The Theracycle
seat can be:
• Raised or lowered
• Moved forward or backwards.
• Increased or decreased the amount of empty space
between the seat base cushion and the back-support cushion.
Raising or lowering the seat
To determine the proper seat height, sit on the Theracycle, place one foot in
the pedal that is furthest away from you and center the ball of your foot on that
pedal. When your seat is adjusted correctly, your leg will be slightly bent and
relaxed. If it is not adjusted to your satisfaction, follow these directions:
1. (Note: you must be off the Theracycle to raise or lower the seat.) Locate
the seat height adjustment knob located below and behind the seat.
Unlock the pressure on the knob by turning it slightly counterclockwise.
Pull out the knob in order to raise or lower the seat.
2. While pulling out the knob, put one hand on the bottom seat cushion,
apply some downward pressure, then raise or lower the seat until you
have the correct height and the knob fits into the appropriate hole. You
will
To Next Page
Loading...