THERMACUT EX-TRAFIRE 100SD - Machine Torch Operation and Alignment

To Next Page

To Previous Page

EX-TRAFIRE

100SD

Operator Manual, Revision T-54-42

Alignment of the machine torch

Mount the machine torch perpendicular to the material to be cut, use a square to align the torch

at 0° and 90°, if torch alignment is not possible, check the cutting table for level to obtain a true

vertical cut�

Operating the machine torch

WARNING

Plasma arc is generated immediately

when the CNC start signal is ON�

The plasma arc will cut quickly through gloves and skin�

Make sure the power supply is switched off before changing consumables�

• Keep away from the torch tip�

• Do not hold the piece that is to be cut and keep your hands away from the cutting path�

• Never point the torch toward yourself or toward others�

• Never use with the pendant control switch�

Important:

In case of operation of the power supply equipped with 23 m long torch you have to increase

dynamic gas pressure to value 6�5 bar�