EX-TRAFIRE
®
100SD
Operator Manual, Revision T-57-50
Fault This may mean Cause Solution
Cut quality
issues�
• Incorrect current
setting�
• Poor quality� • Adjust the current to suit
the thickness of material
to be cut�
• Consumables
fault�
• Consumables are
worn�
• Inspect consumables – see
section Consumable part
inspection�
• Incorrect cutting
technique�
• Poor cut quality� • Adjust the current to suite
the cutting speed and
torch-to-workpiece distance
according to the thickness
of material to be cut�
• Poor connection� • Workpiece is dirty /
contaminated�
• Clean the surface of the
workpiece�
To Next Page
Loading...