en-us Faults – what to do?
26
3 Faults – what to do?
Fau l t s – wh a t to do?
Before you call customer service, use this table to check whether you can rectify the fault yourself.
Appliance
--------
Temperature differs greatly from the set value.
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance" on page 13
If the temperature is too warm, check temperature again after a cou-
ple of hours.
If the temperature is too cold, check temperature again on the follow-
ing day.
Displays do not light up.
The power plug has not been inserted properly. Connect the power plug.
The fuse has tripped. Check the fuses.
The power has failed. Check whether the power is on.
The refrigeration unit is switching on more frequently and for longer.
The appliance was opened frequently. Do not open the appliance unnecessarily.
The ventilation openings are covered up. Remove obstacles.
Large quantities of fresh food have been put in. Switch on super cooling promptly in advance.
Appliance is not cooling, display and lighting are lit.
Demo mode is switched on. Switch demo mode off.
~ "Switching demo mode on or off" on page 17
The door does not open when pressed.
A special mode has switched off automatic door opening. To open the door, reach from below underneath the bottom panel of
the unit or switch off special mode.
~ "Switching Sabbath mode on or off" on page 18
Pull-to-open is switched on. Switch the appliance to Push-to-open.
~ "Automatic door opening" on page 16
The opening force is set too high. Select a lower setting for the opening force.
~ "Automatic door opening" on page 16
The fuse has tripped. Check the fuses.
The power has failed. Check whether the power is on.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
