EasyManuals Logo

Thermador T36IT902NP User Manual

Thermador T36IT902NP
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
en-us Installation and connection
8
Before using for the first time
1. Remove information material, adhesive tape and
protective foil.
2. Clean the appliance.
~ "Cleaning" on page 23
Water connection
9 CAUTION
Installation and connection of the appliance
must be carried out by authorized technicians
according to the installation instructions
supplied.
To avoid damage to the appliance and to
ensure its proper functioning, it should only be
connected to a drinking water system.
To avoid water damage, a shut-off valve must
be installed.
Water pressure of drinking water system
9 CAUTION
To avoid damage to the appliance, a pressure
relief valve must be installed between the
drinking water connection and the tubing,
should the water pressure exceed the
maximum value.
Note: If the water pressure is too low, this will impair
the relevant functions of the appliance.
Min. 0.2 Mpa (2 bar / 29 psi)
Max. 0.8 Mpa (8 bar / 116 psi)
Electrical connection
9 CAUTION
Do not connect the appliance to electronic
energy saver plugs.
Note: You can connect the appliance to mains-
controlled and sine-controlled inverters.
Mains-controlled inverters are used for photovoltaic
systems which are connected directly to the national
grid. Sine-controlled inverters must be used for
isolated applications. Isolated applications, e.g. on
ships or in mountain lodges, are not directly
connected to the national grid.
1. After installing the appliance, wait at least 1 hour
before connecting it to prevent damaging the
compressor.
2. Check that the outlet was installed according to
the regulations and complies with the
requirements.
Requirements for outlets
Maximum simultaneous load
3. Connect the appliance to an outlet near the
appliance.
The outlet must also be freely accessible
following installation of the appliance.
9 WARNING
RISK OF ELECTRIC SHOCK!
Never use multiple outlets, extension cords
or adapters.
The appliance must be grounded correctly.
Never cut through or remove the power
cord's third conductor (grounding
conductor).
9 WARNING
RISK OF ELECTRIC SHOCK!
If the power cord is too short, never use
multiple outlets or extension cords. Instead,
please contact customer service.
Outlet with 110 V ... 120 V
Protective conductor 60 Hz
Fuse 10 A ... 16 A
Appliance 6 A

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Thermador T36IT902NP and is the answer not in the manual?

Thermador T36IT902NP Specifications

General IconGeneral
Typebuilt-in
Stylefrench door
Colorstainless steel
Total Capacity19.9 cubic feet
Refrigerator Capacity13.9 cubic feet
Freezer Capacity6 cubic feet
Humidity Controlled Crispersyes
Defrost Systemautomatic
Quick Freezeyes
Number of Refrigerator Door Binsyes
Interior Lightled
Dispensernone
Ice Makeryes
Water Filterno
Door Alarmyes
Smart Homeyes
Annual Energy Consumption585 kilowatt hours
Voltage120 volts
Current10 amperes
Weight and Dimensions IconWeight and Dimensions
Depth24 inches
Height83 3/4 inches
Width35 3/4 inches
Net Weight459 pounds

Related product manuals