Thermal Solutions AMP 400 - Appliance Wiring and Pump Connections; Low Voltage and High Voltage Wiring

AMP 400-1000L I&O Manual 49
XII(continued)
 

 






UL Type CM, AWM
Style 2092, 300 Volt 60 C
E. System and Circulaon Pump Wiring
      
    

 

 

 WARNING WARNING
     
 

Cauon:     


6.3A, SLOW BLOW
5mm X 20mm FUSE
MAX. 5.6A
TOTAL PUMP
CURRENT DRAW
HOT
NEUTRAL
GROUND
120 VAC/60 HZ
POWER SUPPLY
OVERCURRENT
PROTECTION/DISCONNECT
BY INSTALLER
SYSTEM
PUMP
OPTIONAL
DOMESTIC HOT
WATER PUMP*
BOILER PUMP/
PRIMARY PUMP
AND
COMBUSTION
AIR DAMPER
(IF USING
ROOM AIR)
* For indirect water heating with boiler models. Use
Primary Pump for direct water heating with water
heater models.
