Menu selection Meaning Factory setting
RETURN LINE Shows the actual return temperature. The stop temperature, MAX RETURN is within
brackets.
-
BUFFER TANK Indicates the buffer tank temperature, if activated. -
HOT WATER Indicates actual hot water temperature, if activated. -
INTEGRAL Shows the actual calculated value for integral. -
BRINE IN Shows the actual temperature for brine in. -
BRINE OUT Shows the actual temperature for brine out. -
POOL Only appears if POOL is selected. Shows the actual pool temperature. The set pool tem-
perature is shown in brackets.
-
COOLING Indicates temperature.
SHUNT GROUP Only appears if SHUNT GROUP is selected. Shows the actual supply temperature. The cal-
culated supply temperature to the shunt group is within brackets.
-
2ND HEAT CIR. Shows the temperature of the second heating circuit if installed by the buffer tank sys-
tem.
CURRENT Only appears if CURRENT LIMITER is selected. Shows the actual current consumption. The
set value for MAX CURRENT is shown in brackets.
-
8.5 Sub-menu OPERAT.TIME
Menu selection Meaning Factory setting
HEAT PUMP Compressor operating time for both heating and hot water production. -
AUX. HEAT 1 OPERAT. TIME AUX. HEATER 1. -
AUX. HEAT 2 OPERAT. TIME AUX. HEATER 2.
AUX. HEAT 3 OPERAT. TIME AUX. HEATER 3.
HOT WATER Operating time for hot water with compressor. -
COOLING Operating time cooling.
ACT COOLING Operating time active cooling.
8.6 Sub-menu DEFROST
Menu selection Meaning Factory setting
DEFROSTS Total number of defrosts carried out. -
BETW. 2 DEFR The operating time of the compressor in minutes between the two last defrosts. -
TIME LAST DEFR The operating time of the compressor in minutes since last defrost. -
FAN H OFF AT High speed is deactivated at this temperature and low speed is activated. 12°C(range:
10°C / 20°C)
DEFROST CURVE Used to change the angle of the defrost curve using + or– (Change the start temperature
for defrost).
-10°C(range:
-13°C / -7°C)
MANUAL DEFR Used to perform a manual defrost. Started using + or -. 0(range: 0 / 1)
8.7 Sub-menu LANGUAGE
Menu selection
SVENSKA
ENGLISH
DEUTSCH
NEDERLANDS
FRANÇAIS
Installation Guide Domestic heat pumps
Thermia Värmepumpar VMGFP202
49
To Next Page
Loading...
Need help?
General