40
Installing the Remote Status Light - (Option)
Installation
NOTE: Corner mounted light shown. Flush mounted light installs into
recessed opening (See “Flush Mount Status Light Opening
Dimensions (Option)” on page 17.
1. Mount the Status Light in a location that is visible in the tractor mirror
to the driver.
• Mark and drill the four mounting holes using a 3/16'' drill.
• Mount the status light in position with the supplied rivets.
2. Route harness as shown allowing a “drip-loop” to prevent water from
migrating into the Status Light.
3. Secure harness to the bracket and trailer using the supplied clamps and
rivets.
4. Connecting the Status Light harness to the matching connector located
inside the unit attached to the roadside engine mount.
IMPORTANT: DO NOT secure excess harness to battery cables or
electrical harnesses.
To Next Page
Loading...
