Need help?Do you have a question about the Thermo Scientific 49iQ and is the answer not in the manual?
General| Brand | Thermo Scientific |
|---|---|
| Model | 49iQ |
| Category | Measuring Instruments |
| Language | English |
Explains the calibration menu for system calibration and data viewing.
Details the process for calibrating the instrument's zero background reading.
Explains how to set the span concentration and calibrate the O3 coefficient.
Provides manual calibration options and access to calibration history.
Details manual adjustment of zero background and span coefficient.
Describes how to manually adjust the zero background of the instrument.
Explains how to manually adjust the span coefficient.
Accesses menus for status, alarms, user preferences, and communication.
Views instrument status, alarms, diagnostics, and maintenance history.
Provides information on module alarms, instrument readings, and setpoints.
Anticipates maintenance needs, reduces downtime, and aids troubleshooting.
Reminds users about scheduled component servicing or replacement.
Shows suggested service intervals and remaining time for component replacement.
Logs component servicing and the type of fix performed.
Configures instrument parameters and settings for concentration readings.
Calibrates pressure sensors to zero, span, or factory default values.
Configures various instrument settings like display, alarms, clock, and pump.
Views and sets settable alarm minimum and maximum values for various parameters.
Sets the instrument access level to View Only or Full Access.
Updates instrument firmware using a USB flash drive.
Downloads various data types (reports, logs, history) to a USB drive.
Outlines steps to prepare the instrument before starting calibration.
Details tests and preparation for the calibration photometer system.
Verifies instrument linearity to ensure proper operation and accuracy.
Describes the overall process for performing a multipoint calibration.
Details the procedure for adjusting the instrument's zero reading.
Explains how to adjust the instrument's span to a known concentration.
Describes plotting the calibration curve based on experimental points.
Outlines procedures for regular verification of zero and span calibration.
Details manual adjustment of zero background and span coefficient.
Programs automated zero and span calibration or checks.
Provides step-by-step instructions for rebuilding the instrument's pump.
Outlines the procedure for performing a leak test on the instrument's system.
Provides general troubleshooting information, checks, and recommendations for instrument problems.
Lists safety precautions before performing any servicing procedures.
Explains how to obtain and install new instrument software versions.
Describes how to remove and replace the instrument's measurement side assembly.
Explains how to replace the peripherals support board or system controller board.
Provides instructions for replacing the DMC pressure and flow board.
Details the procedure for replacing the instrument's pump.
Details how to replace the instrument's power supply unit.
Provides instructions for replacing the Step POL board.
Outlines procedures for servicing the Photometer DMC, including lamp and detector replacement.
Details how to remove and replace the photometer lamp.
Explains how to remove the Photometer DMC assembly.
Provides instructions for replacing the Photometer DMC board.
Describes how to remove and replace the pre-amplifier/detector assembly.
Details how to replace the detector board.
To Next Page