Need help?Do you have a question about the Thermo Scientific 43i and is the answer not in the manual?
General| Brand | Thermo Scientific |
|---|---|
| Model | 43i |
| Category | Measuring Instruments |
| Language | English |
Outlines the steps for setting up the instrument, including connecting lines.
Used to calibrate zero and span for the instrument.
Provides access to diagnostic information and functions for troubleshooting.
Displays monitored items and their alarm status.
Details procedures for zero/span calibration, including duration and data considerations.
Describes the procedure for performing zero/span checks to verify accuracy.
Procedure for performing a leak test to check for leaks.
Procedure for rebuilding the pump, including required tools and kits.
Guides designed to help isolate and identify instrument problems.
Safety precautions for service procedures, restricted to qualified personnel.
Procedure for replacing the instrument's pump.
Procedure for replacing the optical bench assembly.
Procedure for replacing the flash lamp.
Procedure to adjust the flash lamp voltage.
Procedure for replacing the photomultiplier tube.
Procedure for replacing the PMT high voltage power supply.
Adjusts PMT voltage after component replacement or range changes.
Tests analog outputs by comparing front panel display to meter readings.
Calibrates analog output channels if readings differ or after component replacement.
Calibrates analog input channels to zero volts.
Procedure for replacing the pressure transducer assembly.
Calibrates the pressure transducer.
Procedure for replacing the flow transducer.
Calibrates the flow transducer.
Calibrates the ambient internal temperature for the instrument.
To Next Page