Need help?Do you have a question about the Thermo Scientific Accela Open Autosampler and is the answer not in the manual?
General| Type | Open Autosampler |
|---|---|
| Temperature Control | 4°C to 40°C |
| Compatibility | Thermo Scientific LC systems |
| Injection Volume Range | 0.1 to 100 µL |
| Sample Cooling | Yes |
| Sample Heating | Yes |
Introduces major components of the Accela Open Autosampler.
Details the primary hardware parts of the autosampler system.
Details the procedure for unboxing system components.
Provides step-by-step instructions for assembling the autosampler.
Explains how to install the cooled stack module onto the table.
Covers setting, controlling, and managing temperature alarms.
Lists recommended maintenance steps and intervals for the autosampler.
Provides solutions for common error messages and symptoms.
Lists and explains PAL firmware error codes for version 4.1.x.
Procedure for creating a backup file of the PAL firmware.
Steps for upgrading the PAL firmware to a new version.
Provides troubleshooting steps for PAL Loader software.
Guides on installing 6-port and 10-port valves for column selection.
Describes how to create a system backup file.
To Next Page