To Next Page
B
Brent PalmerAug 7, 2025
Why does the Thermo Scientific Locator 6 Plus Laboratory Equipment level monitor alarm sound intermittently?
- KKyle GilbertAug 7, 2025
The intermittent alarm and incorrect liquid level measurement in your Thermo Scientific Laboratory Equipment are likely due to ice or frost buildup on the transducer. To resolve this, remove the cover with the monitor from the vessel and let it sit at room temperature for about two hours, or until no ice is visible on the transducer or tube. Do not use a heat gun, as it can damage the cork. Ensure the lid stands upright on the cork to allow moisture to drain. Wipe moisture from the tube's inside and transducer's face with a clean, soft cloth. Then, replace the cover with the monitor and press the “Reset” button.
General
