Versa star Benchtop Meter
Thermo Scientific Orion
General Information
This literature provides basic instructions on operating the Thermo Scientific
™
Orion
™
Versa star
™
meter when one or
more Versa star measurement module is installed. For comprehensive information on meter and module system setup,
operation and advanced features, please refer to the Versa star user manual available on the Versa star literature CD
or www.thermoscientific.com/water.
Preparation
Power Adapter
A universal power adapter with US, EU, UK and China plug plates is included
with the meter. Use of other power adapters can damage the meter and void the
warranty. The use of a surge protector or UPS is also recommended.
1. Select the appropriate plug plate for the power outlet.
2. Remove the clear plastic cover from the back of the power adapter.
3. Slide the plug plate into the groove on the back of the power adapter.
4. Connect the assembled power adapter to the outlet and meter input labeled
POWER.
© 2014 Thermo Fisher Scientific Inc. All rights reserved. All trademarks are the property of Thermo Fisher
Scientific and its subsidiaries.
North America
Toll Free: 1-800-225-1480
Tel: 1-978-232-6000
info.water@thermo.com
thermoscientific.com/water
Netherlands
Tel: (31) 020-4936270
info.water.uk@thermo.com
China
Tel: (86) 21-68654588
wai.asia@thermofisher.com
India
Tel: (91) 22-4157-8800
wai.asia@thermofisher.com
Singapore
Tel: (65) 6778-6876
wai.asia@thermofisher.com
Japan
Tel: (81) 045-453-9175
wai.asia@thermofisher.com
Australia
Tel: (613) 9757-4300
in Australia (1300) 735-295
InfoWaterAU@thermofisher.com
Water Analysis Instruments
IS-68X591201-B 0614
Instruction Sheet
Diagnostics Menu
Access the Diagnostics menu to initiate a meter reset, test electrode stability, perform a meter self test or view meter
and module serial numbers and software revisions.
Main Menu Settings
Factory Reset
All meter settings are reset to factory defaults. Data log, calibration log and methods are deleted. Default password
is 1111.
User Reset
All settings for the selected channel are reset to factory defaults. Methods without a password are erased. Data log
and calibration log are retained.
Stability Test
Tests the stability of a pH, ORP or ISE electrode by measuring the mV per minute drift and noise of the electrode.
Only channels with a BNC input can be selected.
Self Test
Perform a keypad check, accuracy check (channels with BNC input only) and stirrer check (stirrer probe required). A
self test is also performed automatically by the meter at each power up.
About Meter
Displays the meter and module software revisions and serial numbers. The meter and module serial numbers and
software revisions will be different.
Data Transfer
If measurements will be saved to the data log and then transferred to a computer or printer, make sure the data log
setting is on, the meter communication settings match the external device settings and the meter and external device
are properly interfaced.
The Versa star USB driver must be installed on the computer when interfacing the meter and computer via USB.
Thermo Scientific
™
Orion
™
star Com
™
computer software facilitates the transfer of calibration and measurement data
from the meter to a computer and can be downloaded for free at www.thermoscientific.com/OrionMeters.
To Next Page
Need help?
General
