Thermo Scientific Precision GP 2S - Page 44

Precision | 2-3Thermo Scientific
General Information | Chapter 2
General Purpose Water Bath Specifications
GP 20 GP 28 GP 15D
Reservoir Fluid Control
Temperature °C
°F
Ambient to 100
Ambient to 212
Set Point Temperature
Range°C
°F
+5 to 100
+9 to 212
Ambient Temperature °C
Range °F
+15 to 45
+59 to 113
Stability @ 37°C ±0.1
Uniformity @ 37°C ±0.2
Heating Output watts 1200 1200 300 and 800
Bath Volume liters
20 28 5 and 10
Overall Bath Dimensions
(L x W x H) cm
inches
39.2 x 55.5 x 23.3
15.4 x 21.8 x 9.2
39.2 x 55.5 x 28.2
15.4 x 21.8 x 11.1
39.2 x 58.7 x 23.3
15.4 x 23.1 x 9.2
Bath Work Area
Dimensions
(L x W x H) cm
inches
29.7 x 50.0 x 15.0
11.7 x 19.7 x 5.9
29.7 x 50.0 x 20.0
11.7 x 19.7 x 7.9 See GP 05 and GP 10
Approximate Weight kg
lb
10
22
12
26
TBD
TBD
Electrical
Requirements (VAC/Hz)
(Voltage ±10%)
100-115/50-60
or
200-230/50-60
Compliance CE RoHS
UL WEEE
Maximum Relative
Humidity
(Non Condensing)
80% for temperatures up to 31°C (88°F)
decreasing linearly to 50% relative humidity at 40°C (104°F)
Operating Altitude meters
feet
Sea Level to 2000
Sea Level to 6560
Overvoltage Category II
Pollution Degree 2
Storage Temperature °C
Range °F
-25 to +60
-13 to +140
Low-end reservoir fluid control temperatures require supplemental cooling.
Specifications obtained at sea level using water.
Thermal beads may be used instead of water but they will degrade the bath's uniformity and stability.
Bath depth includes bezel, height does not include lid.
Thermo Fisher Scientific takes no responsibility for damages caused by the selection of an unapproved fluids.
Thermo Fisher Scientific reserves the right to change specifications without notice.