Thermo Scientific Precision GP 2S - Draining; GP Bath Drain Hose

Precision | 3-7Thermo Scientific
Installation | Chapter 3
Draining
Drain the bath before moving or storing.
Ensure the fluid is at a safe handling temperature, ~40°C or lower. Wear protective
clothing and gloves.
• Place a suitable receptacle underneath the drain.
• Slowly turn the drain plug until flow is observed.
• When the flow stops close the drain plug.
Draining (GP 10, GP 20, GP 28 and GP 15D only)
• Remove the drain hose from its housing and insert the fitting into the drain quick disconnect.
• When the flow stops remove the hose and reinsert it back into the housing.
CAUTION
Figure 3-3 – GP Bath Drain Hose