Thermo LabSystems Multiskan EX - 4. SERVICING (continued); 4.4 Disinfection Procedure

1. Handle
2. Upper lenses
3. Iiall element sensor
4. Position of the
Figure
12. Lifting the detector Pme
of infwtious agenB as follows:
Turn bhe power off and unplug
Use dispasabls gloves.
Clean the insuument outside,
ck
.g. 1 1: 1) and the platc &w (Fig.112) with a disposable cloth dampned
either with
'70 % elhanol or 1 % ohyde.
Remove
the iwosmws(Fi :3,11:4)of themallring assembly coverandre
11.5) inside the measuring
mbly
and the eight focusing lenses at the end o
as above.
NOTE: Do not touc
The upper lenses ape si
emtor frame (Fig. 1 I:@. Remove ae two de lor fme raseners wilh
washers (Fig.
1 1:9). Li
tPMn the kandle(Fig. 12: 1). elm the up
,1212) by the same
way as focusing lenses.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com