Need help?Do you have a question about the Thermo Orbitrap Fusion Series and is the answer not in the manual?
General| Scan Speed | Up to 20 Hz |
|---|---|
| Mass Accuracy | <1 ppm RMS |
| Ion Source | Electrospray Ionization (ESI), APCI, APPI |
| Mass Analyzer | Quadrupole, Orbitrap |
| Data Acquisition Modes | SIM, PRM |
| Fragmentation Techniques | Collision-induced dissociation (CID), High-energy C-trap dissociation (HCD), Electron-transfer dissociation (ETD) |
| Software | Thermo Scientific Xcalibur |
| Weight | Approximately 300 kg |
Explains warning labels and symbols for safe operation and potential hazards.
Provides contact information for customer service, technical support, and feedback.
Introduces the Orbitrap Fusion MS and Lumos MS, their components, and system setup.
Details front panel LEDs, power entry module, and communication connectors for system status.
Explains scan types, rates, mass ranges, data types, and polarity modes.
Details the vacuum system's block diagram, gas supplies, manifold, gauges, and pumps.
Describes the ion path, optics, analyzers, and detection systems.
Details the external syringe pump and divert/inject valve for sample introduction.
Covers procedures for system startup, shutdown, standby, and resetting components.
Outlines daily checks, flushing, purging, and standby procedures for optimal performance.
Provides a schedule for maintenance tasks and general guidelines for component care.
To Next Page