Thermo Orbitrap Fusion Series User Manual

6
System Shutdown, Startup, and Reset
Restarting the Data System
Thermo Scientific Orbitrap Fusion Series Hardware Manual 57
Restarting the Data System
If possible, use the Windows restart procedure to shut down and restart the data system so
that Windows can properly close applications and save changes to any open Thermo
application.
 To restart the data system by using Windows
1. On the Windows taskbar, choose Start, and then click the arrow next to Shut Down.
2. Choose Restart, and then click OK.
 To restart the data system by using the power button
1. Press the power button on the data system computer.
2. Wait at least 20 seconds after the computer shuts down.
3. Press the power button again.
Note After you reset the data system, the communications link between the data system
and the mass spectrometer is automatically reestablished. When this occurs, the
Communication LED turns yellow and then green. If the system is unable to reestablish
the communications link, hold down the reset button for 3 seconds.

Thermo Orbitrap Fusion Series Specifications

General

Brand	Thermo
Model	Orbitrap Fusion Series
Category	Laboratory Equipment
Language	English