Thermo LabSystems Multiskan EX - 4. SERVICING (continued); 4.7 Changing the Fuses

Figure 13. Changing the lamp
The fuses are imtd at the rear of the insmrnent (Fig. 83).
Switch he power oft
Unplug the insuument and disconnect the power cord from the power input smkec.
Unscrew the caps of the fuse holders (Fig. 14).
Replace the blown fuss with che same t
Screw the caps back onto the fuse holdees.
Reconnect he power cord and switch the
Figure 14. Changing ik fuses
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com