Thermo LabSystems Multiskan EX User Manual

Data transfer (o a computer occur via a built-in serial WS-232C interface
ifimsions of che RS-232C interface ape as foI1ows:
1.
The configmation is s ifid as for data teminal equipment @E).
2. The baudrat en m external computer and insmmenc) is sef~kd b
board. The following baud nmaseavailable: 2400and 9
3.
Chzwter format is 10 bits wiLh 1 5 bit, 8 data bits. 1 stop bit and no pariry. The format cannot be changed.
4. XON/XOFF software flow conbol can be us SIC% handshake
alternative is
selecred by a DL switch on fh CU-RC p~ocess
The following signals are connected to che DB-25 connector at the rear of rhe insmmenr
Signal descPiption:
2.
TxD. Tmsmit Data wqur
is in the high state when MuIris
tween
Muttiskan R
switch 3 (Fig. 9).
sw3 Baud rare
off 9
on 2
To deternine which baud rate is n
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Thermo LabSystems Multiskan EX Specifications

General

Brand	Thermo
Model	LabSystems Multiskan EX
Category	Laboratory Equipment
Language	English