Thermo LabSystems Multiskan EX - Page 59

The user can defiie the smdard line by enre
d the intercept
by using the known
stan
the concenm-
tions with the following equation:
absorbance
=: Ax concentmion + B
where
like in linear srandard mode.
The measmment parame==. calcula(ion
pamineern and cowenmations
obtained we sent
co the built-in pYinter or via the interlace.
5 LIMIT CAECULATION: with a limit value
limik negative sign
). The maupement p
sent to the built-in
6 UBLE LIMIT: 7he measwed absorbace values with two limit values
defined by the
user. If heresdais lowerth
erlimir,anegalivesign
f-) i
e result is between the two limit values,O is sent. if the result
is h the lrpp~r limiL gasitive sign (+) is sent. The measurement
parameem. dculaeion p and results in -PI+ m
sent to the
build-in peinter or via th
Low limit value
High limit value
7 RANGEC ATTON:
fmm 0 lo 9. The
Enample:
If an abs~banse range 1.5 is
the segmenrs are as Mow:
Measured absorbance value in range
AS 0.150
O.lSO<A 50.300
0.300
< A 5 0.4%
0.900 < A 5 1.0
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com