Thermo LabSystems Multiskan EX - Page 62

The following calculation modes and dculahon paramelers can
NO CKCUI-A%ION
DOUBLE LIMT
Results are sent as absefbances to built-in printer or via the interface.
The banm values
are c with two limit values
defin therwdt
is lowerth er limir,a negative sign
(-) is sent If the result is between the two limit values, 0 is sent. if tbe result
ded into ten equal segments.
measwed abmbance due is
represented by one of
rs depending on whi
in.
The measuremen
t numben (0 ... 9) are sent to the
built-in printer or via the inmface.
Parameen: Range value
Example:
ff an absor
e mge 1.5 is set, the segments are as below:
Mawed absorbance value in range
A S 0.150
0.1SQ < A i; 0.300
0.300 A r; 0.4
1.206 < a 5 n.350
1.350 .:A r; 1.5BB
wilh a cut oFf valuecaleula-
ted wilh theaidof acutoffecqua6sn usingm absohanws orpositive
or negative contmls.
S CONTROL Al
NEG CONTROL A1
Example: 0"+1\1)x0.9
LOW POS CONTROL A1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com