Thermo LabSystems Multiskan EX - Page 71

I. Handle
2. Upper lenses
3. %I1 element sensor
4.
Position of the Plall element sensor
Figure 12. Lilting the degctor
fnme
Disinfect the insuument in cage of hazard of infecuous agents as follows:
Turn the power off and unplu
Use disposable gloves
Clean the instnrment outside,
(he raazk (Fig. 1 I: 1) and the place carrier (Fig.11:2) with a disposable cloth dampcned
either wilh
70 % ethanol or 1 % glucaraldehyde.
Remove the two
screws (Fig. 11:3, 11:Q) of the measuring assembly cover and remove the cover. Clean Lhe mask
(Fig. 11.5) inside the meawing assembly and he eight f~ocusing lenscs at the end of rhc optical libre bundle
(Fig.
I1:n as abve.
NOTE: Do not touch the measuring cirsuil board (Fig. 11:6) by ban
The upper lenscs are situated under rhe detector frame (Fig. 11:8). Remove he two de fme fauners
washers (Fig. 11:9). Lirt thedetector frame from the handle (Fig. 12: 1). Clem the up rienses~ig.12:2)by *cwmc
way as focusing lenses.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com