Thermo LabSystems Multiskan EX - Page 73

Figure 13. Changing the lamp
The fuses are located at the rear of the instrument (Fig. 83).
Switch the power off.
Unplug the insuurnent and disconnect rhe power cord from the power input swkek
Unscrew the caps of the fuse holders (Fig. 14).
Replace the blown fuses wirh the same type.
Screw the caps back onto the fuse holders.
wer cord and switch the power
on.
Figure l4. Changing the fuses
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com