@
RC
carefully and checkPor
any
age that may havebcen cauM
during
rrans
part
is
damaged or missing. contact the local Labsystems represenlative.
Keep the original package for future mspamrion.
XC
to
avoid
exposure
to
excess
dust,
vibrations. strong magnetic fields,
disecr
sunlight,
draft,
excessive moisture
OK
large
ternpr;tlwe Ructuations.
Leave sufficient clearance
(10
cm) at both sides of the unit for adquace
air
circularion.
Remove the two cover relairing screws (Fig.12)
and
ljft
up
the
cover.
1.
lnsburnent cover
2.
Retaining screws of the insmment cover
3.
Measuring assembly cover
4.
Reraining screws of the measwing assembly cover
5.
Plale carrier
6.
Transfa
mils
9.
Track
Figure
1.
Multiskan
RC
Unpack
the
filter
wheel. Chwk thar all films are
clan
and
undamaged.
Plx
1
inla the
filer
slo(
(Fig.
25)
so
that
the
toothed edge
faces
the
rear
of he insvurnent.
A
magnetic locking m will automarically
lack
the
wheel in thccomecc position
and
he optical
filter
position
sensor
will
rn
measuaemenl
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
