User Manual
13.
Configuration parameters
Controller parameters grouped in functional folders (CF = configuration, CO = compressor,…) with a specific
label each.
The generic group ALL contain all controller parameters.
There are 3 different level: user level without password and the other two, only for authorized technician,
available with password.
How to enter in “Pr1”:
1. Press and for some seconds;
2. Icons flash and upper display shows “ALL” (generic parameters group);
3. Slide the parameters groups using and ;
4. Select the group that contains parameters to edit. Pressing the set button, you can enter in the
parameters list of that group.
Lower display shows parameter label and the upper its value.
5. Select parameter;
6. Press the key to eneble the edit;
7. You can edit the value using or ;
8. Press the button to save the new value and to move to the next;
9. To exit, press the key, when you are in parameters viewing (not during the change with
blinking value), or wait the timeout.
NOTE:
The new value is saved also, when you quit because of timeout without pressing the button.
To Next Page
Loading...