Need help?Do you have a question about the ThermoFisher Scientific thermoscientific F6000 and is the answer not in the manual?
General| Brand | ThermoFisher Scientific |
|---|---|
| Model | thermoscientific F6000 |
| Category | Laboratory Equipment |
| Language | English |
Definitions of WARNING, CAUTION, and NOTE symbols for hazard identification.
General safety and operational advice for the furnace.
Specific warnings to avoid electrical shock, burns, and personal injury.
Warning regarding insulation materials and potential carcinogens.
Specifies the furnace's purpose as a general laboratory and heat treating unit.
Advises against using the product for anything other than its intended purpose.
Explains how the furnace chamber is heated and controlled.
Details operating and storage requirements for the furnace.
Instructions on placing the furnace for optimal operation and safety.
Guidance on connecting the furnace to the power supply.
Specific network supply requirements for operation in the EU.
Explanation of the ON/OFF switch and its indicator lights.
Describes the function of the cycle light indicating heating element status.
Details the function and testing of the door safety switch.
Overview, basic operation, buttons, and indicators of the Eurotherm 3216 controller.
Adjusting setpoints, viewing units, and accessing controller parameters.
Details on alarms, sensor protection, OTP, and auto-tuning.
Explains the two modes (DWELL, DELY) for ramp and dwell programming.
Details setting program modes, ramp rates, dwell times, and end types.
Instructions for setting the ramp rate limit for setpoints.
How to start, pause, and stop a programmed sequence.
How to check if a program is running, paused, or stopped.
Overview of the controller, its display, buttons, and basic operations.
Setting setpoints, ramp rates, units, and auto-tuning.
Parameter levels, alarms, diagnostics, sensor protection, and OTP.
Details on 8-segment and 5x16-segment programming, including timers.
Details the wiring for RS 485 communication.
Information on adapters for connecting RS 485 to PC/USB/Serial.
Software needed for data logging and control.
Table of communication settings for the 3216c/p controller.
Steps to resolve common communication problems.
Instructions for connecting the compressed air supply.
Guidance on connecting an exhaust system for fumes.
How to position and adjust the furnace shelves.
Steps for operating the furnace using air control features.
How to clean the exterior surfaces of the furnace.
Guides for replacing heating elements and thermocouples.
Guides for replacing solid state relays and door switches.
Guides for realigning door strike and replacing the controller.
Electrical schematic for single setpoint models.
Electrical schematic for single setpoint models with OTP.
Electrical schematic for 8-segment programmable models.
Electrical schematic for 5x16 segment programmable models.
Details on safety standards and testing by CSA and NRTL.
FCC and Canadian IC statements on EMC performance.
Information on Proposition 65, EU Directives, REACH, and RoHS compliance.
European Union directive for Waste Electrical and Electronic Equipment.
To Next Page