15
Technical Manual
© 2006 by Thermoplan, Subject to change
Tiger REV-8
SECTION 3Menu 6
6-4 Operating Mode
Doupble Product
In menu 6-4 you can set the operating mode „Double Product“.
Double Product: 2 beverages on single products keys possible
6-6 POD Products
On
6-7 Rinse Key
On
6-8 Grinder Key
On
6-9 Milksort Key
On
6-11 Mains Voltage
230V
6-13 Water Source
Waternet
6-15 Sens Drip Tray
No
In menu 6-15 the later styles of drip trays have a Reed switch installed.
Remark: Note that older styles drip trays do not have a Reed switch. In such cases the Drip Tray option in menu 6-15
must be set to „No“.
6-16 Numb Grinders
2
In Menu 6-16 you can set the amount of grinders.
1 or 2 grinders.
6-17 Milk Source
In menu 6-11 you can set the available mains voltage with the Plus-/Minus levers.
230V or 115V.
In menu 6-13 you can set „Water net“ (no Water tank in base) or „Tank“ (with Water tank in base)
with the Plus-/Minus levers.
In menu 6-6 you can set the POD Products with the Plus-/Minus levers.
On: POD Products active
Off: POD Products closed
In menu 6-7 you can set the Rinse key with the Plus-/Minus levers.
On: Rinse key active
Off: Rinse key closed
In menu 6-8 you can set the Grinder key with the Plus-/Minus levers.
On: Grinder shift key active
Off: Grinder shift key closed
In menu 6-9 you can set the Milksort key with the Plus-/Minus levers.
On: Milk shift key active
Off: Milk shift key closed
In menu 6-17 you can set the Milk source with the Plus-/Minus levers.
1x Internal : 1 Milk sort in base
2x Internnal : 2 Milk sort in base
1x External : 1 Milk sort external with niveau sensor
2x External : 2 Milk sort external with niveau sensor
1x External withaout sensor : 1 Milk sort external without niveau sensor
To Next Page
Loading...
