16
Technical Manual
© 2006 by Thermoplan, Subject to change
Tiger REV-8
SECTION 3
Menu 6
6-20 Cold Milk
Yes
6-21 Purge Activ
6-22 Cup Heater
6-23 Interface Option
No Interface
In menu 6-23 you can set the interface options. This setting depends on the used interface.
Options:
No Interface / CCI ((If an interface is connected, this must be adjusted)
6-24 Currency
EUR
In menu 6-24 you can set the desired currency with the Plus-/ Minus levers.
This menu appears only if menu 6-23 „Interface Oprion“ is activated.
In menu 6-21 the Purge Valve can be activated or deactivated.
Purge active: In case of milk tank option or external milk supply wehre milk source is placed
below the machine.
Purge inactive: If case of externel milk option wehre milk source is placed on the same level
or next to the machine.
In menu 6-20 you can swith-on the valve for the cold milk active or inactive with the Plus-/Minus levers.
Yes: Cold milk valve available
No: Cold milk valve not available
In menu 6-22 you can activate the cup heater with the Plus-/Minus levers.
Yes: Cup heater available
No: Cup heater not available
6-22 NTC Dampfrohr
No
In menu 6-22 you can set the steam options.
Yes: Steam activated
No: Steam deactivated.
6-26 Reed Thermoblock
Yes
In menu 6-26 you can set the Reed from the thermoblock on or off. Yes or No. This menu point is for the labyrinth plate.
If the plate not in the thermoblock or not correct xed, there is a message on the display.
6-27 Light Barrier
ON
In menu 6-27 you can activate the light barrier that supervises the grounds drawer not to overll.
ON or OFF.
6-28 Fan Monitoring
Yes
In menu 6-28 you can set the Supervision of the Fan on or off. Yes or No.
To Next Page
Loading...
Need help?
General
