User’s manual User’s manual
GB
79
10.2 - Switching your radiator on/off
Press the button
for a few moments
The screen lights up and indicates
the default temperature
To put your radiator
on stand-by, press
an hold
(long
press) until «OFF” is
displayed.
The radiator displays «OFF” and
then goes off.
10.3 - Switch the screen on
If the screen is not
backlit, press any
button to switch the
screen on.
The screen lights
up.
10.4 - Temperature setting
To activate the screen, press on any key.
The temperature by
default is 19°C.
You can vary this by
pressing on the keys
and .
Press the button to conrm
The heating light indicator
is displayed on the screen if the ambient temperature is
lower than the displayed temperature (set temperature).
Wait for at least 6 hours until the temperature stabilises.
The black arrow moves along the consumption indicator between the green and the red
levels. The temperature recommended by Ademe (French Agency for the Environment &
Energy control) is 19°C, and this arrow informs you if your behaviour is within or outside
the recommendation.
10.5 - Set the day and time
To reach the “set day
of the week”
menu , press
.
Equilibrium
Set : D/H/Min
«Set D/H/Min» is displayed on
the text line.
Press
to access
the “set day of the
week” submenu .
OK
ay
The rst two letters of the day
of the week blink.
Select the day of the
week by pressing the +
or – buttons and then
conrm by pressing
.
OK
Set: Hour
Once the day has been
conrmed, the hours blink.
Select the current hour
by pressing the + or –
buttons and conrm by
pressing
.
OK
Set
inute
Once the hour has been
conrmed, the minutes blink.
Select the current
minutes by pressing
the + or – buttons and
conrm by pressing
.
OK
Set : D/H/Min
Once the minutes have been
conrmed, the settings menu is
displayed again.
To quit the settings
menu, press
.
Equilibrium
Day Hour
Return to the standby screen.
Equateur2_1880-1585_interieur.indd 79 18/06/12 06:23
To Next Page
Loading...
Need help?
General
