TLX Matrix Switch ASCII API V5 13 Rev. I, January 2019
XOPTIONS
This command returns a numeric response that is a bit map of options available in the version
of the API. The value returned is a four-digit decimal number of the binary bit map. For example, if
the value returned was 0015, then bits 0, 1, 2, and 3 would be on (bit 0 is the lsb).
The following bits are defined:
0: Reserved for HDX Matrix Switches.
1: XTEST2 command is allowed. This is set for the TLX320 and TLX640.
2: Only UPPER-CASE commands are allowed.
3: XMAXCARDS returns the total number of cards allowed in the Matrix Switch (not half the number
as it formerly did).
4: Switch supports point-to-point connection mode.
5: If set, the Switch may send status updates using a Multicast IP address instead of a broadcast IP
address.
6: If set, the Switch supports collection on port connection durations. (see the XCTIME command on
pg. 8)
Format: XOPTIONS
Example Results: R0007OK0007
Sample response:
R0062OK0120#xoptions:Actual_Card_Count P2P Multicast Connect_Time
To Next Page
Loading...