Third Reality 3RSM0147Z - Pairing with Home Assistant

Device: Zigbee dongle
Open the battery cover and install the batteries, press and hold the
reset button for 5 seconds and release the hold; The LED light turns
blue blinking, indicating it enters pairing mode.
In Zigbee Home Automation, go to “Configuration” page, click “in-
tegration”.
Then click the “Devices” on the Zigbee item, the click “Add Devic-
e s ”.
Pairing completed.
Back to “Devices” page to find the sensor added.
Click to enter in the control interface to set the sensor.
Click “+” belongs to Automation and add trigger and actions.
1.
2.
3.
4.
5.
6.
7.
Pairing With Home Assistant
Zigbee Home Automation
17