6.3.1 ‘ADVANCE’ submenu
In the ‘ADVANCE’ submenu, further physical settings for the drum pads can be made.
The respective parameters are displayed depending on the trigger.
With double trigger mesh pads, the parameters can be set separately for head and
rim, with the other pads only for head and rim together.
1 Main menu
2 Trigger
3 Values
4 Parameter
5 Scroll bar
Hit the trigger whose sound you want to edit, or select it with | . The display
shows the corresponding name at the bottom right.
Parameter Function
‘SENSITIVITY’ Touch sensitivity of the selected trigger. The higher the value, the higher the sensitivity, but crosstalk and
the avoidance of double hits are simplied.
‘HEADROOM’ Headroom of the selected trigger. The lower the value, the easier it is to play loudly.
‘SENSETIME’ Minimum time interval between two signals from the same trigger. Increase this value carefully to avoid
double hits.
‘PEAK DECAY’ Setting the time period how long after signal input of the selected pad no other signal is accepted. The
higher the value is, the lower the likelihood that notes are skipped, but double triggering is easier.
‘NOTESEND’ MIDI note value of the selected trigger. Change this value if the output MIDI note does not match the
setup of the external software.
‘TRIGGER’ The trigger curve regulates the velocity, i.e. the ratio between the punch and volume. Use setting ‘Linear’
for the most natural ratio between punch and volume. Use ‘Exp’ if you want a hard strike to cause a
bigger volume change (or dynamics). Use ‘Log’ if you want a soft strike to cause a bigger change. With
the setting ‘Spline’ the volume changes less upon a change of the strike. High volumes are already
reached at a relatively low strike intensity (see the following graphic).
Operating
MPS-1000
21
To Next Page
Loading...
Need help?
General
